Ender 3/Pro, Fan Duct Voron style

v1 of my Fan duct for a good old ender 3. Please print in some higher temp materials such as PEGT ASA or ABS.

parts needed 

5015 fan

6x m3 6-12mm screws 

that's it.

install so easy it's dumb. remove old, slide the mounting plate down around the hotend, screw the originals screws in, place fans on the mounts, and ensure it all fits at the wires and is run nicely. then lastly screw the cover on and you're done. Happy printing!

DON'T USE SUPPORT!/only use touching the built plate or you will fill the part cooling air run thingys with supports that will block airflow.