Voron Bearing Top Spool Mount

I've been buying more cardboard spools when available to reduce some of my plastic waste but they tend to get caught on the standard spool holder.  When I had my ender I found a 608 bearing spool holder so I tracked down a similar model for the voron and it's been working wonderfully except my printer is too close to the wall and the added length made changing spools difficult so I wanted to switch to a top mount spool.  Thus we have this mashup. I made this for the Voron 2.4r2 but it should work for any printer with 20x20 t-slot extrusions.

The top mount was based on the linked file on printables  by @RadRacer (https://www.printables.com/model/227260-voron-24-top-mount-single-dual-spool-holder) and the bearing spool holder is the 75mm drum from deathrow360 on thingiverse (https://www.thingiverse.com/thing:5424091)

I had to flip the prongs on the mounting for the top spool bracket since it wouldn't mount flush to the 20x20 extrusions so I would recommend printing this with supports on those prongs.  The tab from @RadRacer's design allows it to replace a panel clip where you mount it.

Printing instructions:

• Print 1x of the spool holders depending on your need, 
  • I printed in ABS at the standard voron specs
  • Paint on or turn on supports on for the prongs, they aren't necessary anywhere else
• Print 1x 75mm drum from here: https://www.thingiverse.com/thing:5424091/files (two if you're printing the dual holder)
• Install two 608 bearings, one on either side of the drum
• Rest the drum in the cage
• Attach the spool holder to the frame using an M5x10 bolt and an M5 t-nut