Ikea Elvarli Helmet hook/holder

Helmet holder for the Ikea Elvarli shelves system.

Print settings

Print in PETG or stronger filament for durability, with these settings (or stronger):
(calculated on a 0.4mm nozzle)

• 4 walls
• 0.2 layer height - 5 top and 5 bottom layers
• 15% infill
• No supports required

Orient the pieces on the bed as in the picture.

The entire print requires about 50 meters of filament (150 grams using PETG) using these settings.

Do not print in PLA, as it becomes brittle with continuous loads.

Required Hardware

• 4 x M5 threaded heat inserts https://amzn.to/3nm1Dgh
• 4 x M5x16mm Hex drive rounded head screws https://amzn.to/3LOuWBn