BMP280 BME280 V Slot Sensor Housing

…Please be sure to hit like & post a make, I'd love to see your prints!

Install your BMP/BME280 sensor on any V-slot.

Or use base with no mount for glue on application.

 Measure temperature, pressure & humidity on your Rpi.

You'll need:

1x BMP/BME280 sensor

2x M3 SHORT heat inserts

1x M3 4mm Cap head bolt

1x M3 10mm Cap head bolt

1x 4 pin DuPont connector 

1x length of 4 core wire the desired length

1x the knowledge to set up the sensor in your chosen system!

Search Octoprint Enclosure or read the Klipper docs

link to sensor used: 

https://www.amazon.com/GY-BME280-Humidity-Temperature-Barometric-BMP280-5V/dp/B097PLZ3ST/ref=mp_s_a_1_15?crid=2US3XFHD41HFU&keywords=bmp280+sensor&qid=1683064786&sprefix=bmp280%2Caps%2C174&sr=8-15

Printing:

Make sure your printer is setup well, this thing is pretty small!

PLA+ 0.20-0.30mm layer height

Print base laying flat

Print cover standing on its flat end that has no vents with supports inside

….you can print it on its lid but the overhang tends to look a bit messy