Blum 561 jig

This jig is compatible with Blum 561 slides commonly found in Ikea bathroom cabinets.

To use the jig, you will need to make a drawers based on the slides you have. You can find design notes here: https://publications.blum.com/2020/catalogue/en/436/ Then you will need to mark, from the back, x2 on the drawer bottom. You can use the line to align the jig as shown in the photos.

I printed the jig using PLA in 0.3 mm draft mode. I had to enlarge the holes a bit using 6 mm and 8 mm drill bits. I made 4 drawers with the jig with great success.