Shave Soap Dispenser

When your collection of soaps gets too messy and you're tired of your stack falling every morning, just pull the one on the bottom and then put it back on top. You'll have a regular rotation! 

V2 is in the works with an extend-able upper section with different heights for more soaps. I'm also probably going to make a micro version for samples. 

This will fit soap dishes that are under 95mm diameter. In my case they are 93mm diameter x 45(ish) tall.  Mine are from Henri et Victoria, a wonderful Canadian company. 

Print with supports for the bottom opening. Use a support blocker for the upper section if required. Or use supports if you want to waste filament :) 

I've included a few height differences for different printers. There's a 210 version to max out a Prusa, the one in the photo is 220, and a 250 is also included to max out an Ender 3.