Ikea Lack Drawer

Size: 14.3mm (wide) by 16.7mm (deep)
Can be used with Ikea Lack tables but it can also be mounted underneath any other flat surface.
Drawer: PLA - 113 gram
Support: needs small support under drawer handle
Rail: can be found HERE in 2 versions: rail and rail-side (use side if there's not another drawer on the other side of the rail)
NOTE that I printed the rail in PETG for strength but it will probably also work in PLA.

Improvements over original drawer:
- drawer handle curved with grip below instead of from above
- outside corners (back) curved
- inner corners curved (stronger)
- inner connection with bottom triangular shaped (stronger)
- fix in front-left corner
- wider than the original 

The drawer .3MF file has some additions, moving the seams to places where they are not really visible.