Universal car phone holder

For mobile phones widths from 70mm to 90mm.
Bracket to ventilator are various versions. One version is for horizontal shovels width 16mm and second for width 11mm.Bracket to ventilator is prolonged by 9mm that leans against upper wall that shovels from ventilator did not tilt to down. Who doesn't or doesn't want, there are shorter versions without prolonged.
Holder screw and nut are on the size key 14mm.

Update: I made stronger rods and their attachment into gears. I hope it helps them do not to break. I made minor adjustments on the body and the rider. Finally, I adjusted the screw holes for the screwdriver

Fix: I made a small adjustment to the gears for a smoother ride.

Update: Added bracket curved 15 angle towards the driver.

Update: Added new versions of the parts :

Back plate, front plate, left and right gear, bracket to phone holder. 

Are little stronger rods of the gears and joints of the back plate with the front plate. Improvement joint of the back plate with the bracket to phone holder. 

Are larger hole on the joints of the front plate with the back plate. 

Are larger hole on the gears. 

All modifications are see on the pictures.

Update: Added new brackets (Double bracket to ventilator curved 15 angle, Double bracket to ventilator) with a gap in the middle for the vertical shovels in the fan to firmly attach to the so that it does not move sideways.

Pokyny k tisku

I Recommend infill 40% of the back plate. Other parts is enough to 15%.
Bracket to phone holder and bracket to ventilator need supports to print. So that the supports can be removed better, put them only on the edges, see picture. Other parts are print without supports.