Crimping Tools under Control

You may be pissed when you have all the (expensive) tools and don't have them by hand when you need them.

So I took Whity's Rugged Box. Brought it to my best fit (F3D parametric). Made an insert blister with individual distancers for each tool. Made the insert fit into the box, with some gap (0.4mm all around) for better fit. Later I glued the insert into the box, the distancers as well.

Now my crimping tools are all in one place and I immediately figure out if somenbody's missing.

The lid I reworked for a symbolic crimping tool, some (fancy) colors.

I printed the box on my Voron 2.4 (350) in PLA camouflage. Lid with some colors and finally also with same PLA (camouflage).

The Latch for a bit more elasicity in PETG. The hinges are linked by Ø3mm dowel pins 32mm wide each.

Make your own insert, and have fun.