Pi 3A+ case w/ Camera

PRINT AT 101% SCALE FOR A PERFECT SLIDE IN FIT!

I liked the case and at first, I didn't need the camera slot. But, as times change and equipment grows. So do needs. So I remixed the lid of the case to contain a ribbon cable slot and air vents. 

With the new design, I had to remove the original logo, which in turn took the cooling vent away, so I added the air vents. I also covered the GPIO pins as I do not use them. If requested I will post a new model with the GPIO pins open as well.

I will also add the bottom and lid of the case from the original design, as I DID NOT CHANGE THE BOTTOM!