Honeycomb Wall - Insert-Empty Rotation

Updates

• May 10, 2023 added version with 3 tabs removed, 3 tabs remaining - as removing all tabs was too much and didn't provide enough stiction in some cases.  The 3 tab version provides middle ground for providing enough “stiction” without being too dificult to add or remove.

Insert-Empty / Empty HSW insert remixed in two ways

• inner hex rotated 30 degrees, to allow HSW to be used on its side
• inner hex allowing for multiple positions 

Additional STLs for the following

• notab = without the Tabs, to allow for easier insertion/removal
• 3tab = with 3 tabs removed, 3 tabs remaining for easier insertion/removal
• nogroove = insert with top groove removed

When combining 3 x HSW into a stand there was better stability laying it on its side but this meant existing attachments couldn't be used as easily.  These Insert-Empty allow placement as though it was natural side up.  

Additional the mutiple positional inner hex can be used with HSW in either its natural side up (vertical) or horizontal side and still use pre-existing design attachments.  Side benefit is that some attachments (as per photo example) could be deliberately placed at an angle i.e. could see benefit of attachments on one edge being angle to allow for more items or more use of available space.