Ki Wall System

Ki Wall is a convenient, aesthetic and satisfying way to store your keys!

Ki Wall features embedded 1.5x6x20mm magnets (available inexpensively online) to keep hold of ferrous keys and objects. 

Non-ferrous keys, or want a cleaner look? Make use of the accompanying Ki Fob! 

Ki Fob also features an integrated magnet - oppositely oriented to the ones in Ki Wall, allowing it to snap effortlessly in to place, and stay there until you need them again. Use sufficient magnets, and your Ki Fobs will snap effortlessly into place!

The symmetrical edge design also means that if you need more than two mounts, you can align multiple Ki Walls seamlessly, allowing for greater flexibility (future further modularity is planned!).

Mounting options include a recess on the rear of Ki Wall for a command picture-hanging strip to hang flush, or alternatively a 6mm Ø lightly chamfered hole for a screw. N.B. pre-sliced .gcode does not include a screw hole, the raw files however do. 

------------------------------------------------------------------------------------------------------------------

Printing instructions:

1. If slicing yourself, ensure you put pauses in the correct positions! Pauses occur before the selected layer is printed, so get to the layer when the magnet recesses are about to printed over, and stop there!
2. Pay close attention to the polarity of your magnets! I marked mine to ensure I got them facing the correct way, once you seal them inside, you can't reorient them!
3. Remember, if printing Ki Wall and Ki Fob together, their pauses will be at different Z heights, you'll need to do it twice. 

The provided .gcode has pauses done for you for inserting your magnets - ensure you double check the polarities in order to put them in the correct way around!