18650 Container

Nice and useful little print.
I added an o-ring for better sealing
Printed with geetech tricolor with 0.2 hight

Added 4mm in height, the battery did not fit

I scaled it by 1% just in case :)

I printed two pieces, for the second piece I lengthened the middle part by 4 millimeters, because I have both "regular" and side-loading batteries that are slightly longer than normal. Printing was shoot and forget... the cases were finished like they were and the quality is good

printing on i3, bad thread on the body side, it broke after screwing in
filament Rosa3D

Thanks great model! Batteries fit perfectly

Va genial la verdad

Lepší než poškrábaná ;)

Great model! I have added a seal ring just for the peace of mind (I will carry spare battery for my bike light, so it might encounter rain).