This cartridge box is printed as separate parts that are printed in orientations chosen to maximize strength and then snapped together.
The box halves require moderate infill (10%-20%) and can be printed with no supports, but I prefer to paint on supports under the flat sections on the latch hoops and the latch catches. I printed with 0.16 layer height in PLA.
Do not use Perimeter Generator: Arachne on the box bottoms.
Assembly instructions:
Push the tabs of the latches through the latch hoops on the box lid until the latch tabs fully lock in place.
Category: Tool Holders & Boxes
The author marked this model as their own original creation.