Mechanical Keyboard Display Stand

A stand to display your mechanical keyboards. Since the left and right stand are identical the print file only contains one. Simply print two for a full set.

• Displays keyboards at a 60 degree angle
• Supports keyboards with up to a 2.5cm front case height
• Needs only 4mm clearance between case bottom and keycaps (Keychron K series fit)
• 18mm wide, the same width as a 1u keycap
• Stable even with heavier aluminum boards

Both a flat and an upright STL are available, while the flat version prints slightly faster in my experience the upright version yields better looking results. Printed mine upright with no supports, 0.1mm layer height on a Flashforge Adventurer 4