put on the printer Bambu AMS drawer Stand

The length has increased and is basically consistent with AMS. With the increased height, opening the drawer will not touch the printer screen. Move the spacer behind the middle to cover the handle. It is recommended to use PAL printing, 0.4mm nozzle, 0.2mm layer height. Do not use ABS or PETG, they are prone to deformation and the drawer may get stuck if the material is deformed. I only printed the frame, not the drawer, the drawer is still the original. Do not mistake the installation direction, it is difficult to disassemble after installation. If it is too tight and difficult to install, apply a little detergent to the interface for lubrication.

Uploaded the drawer (2).3mf file,Due to the high temperature in summer, the cooling speed of the slide rails on both sides of the drawer is slow and sags. I added supports below the drawer slides.The drawer.3mf file is not supported, and I have not deleted it.

If the drawer is not installed correctly and the drawer cannot be completely closed, you can download and print "qian.3mf" for remedy. But this is just a simulation in the software, I didn't actually print it out to check. I hope you look carefully at the installation photos of the drawer before installation, and don't make a mistake in the direction.

placed on the desktop：

https://www.printables.com/model/451511-bambu-ams-drawer-stand