Phillips Hue Wall Switch Cover/Adapater

I designed these to let me replace wall switches with Phillips Hue remotes so that I can leave the switches on and use smart bulbs. There are two circles on the back for magnets, and a passthrough to allow soft resets via the switch. Hope this is helpful for someone! 

Printing Instructions:

For best results, print back-down with a brim and supports. Recommend using 0.16mm layer height or less- I've had good results with Prusament Marble Grey for hiding layer lines. 

PLEASE NOTE: No part of this design is ETL or otherwise certified. These are not approved in any way as electrical components. Use at your own risk.