Remix of Corsair HS70 Can Clip by MattFalbe.
I had made his version originally but the 2 halves didn't seem to connect completely, after some sanding of the part they did fit but this didn't matter as the main thing holding the 2 halves together was the M3 Bolts.
After a few months the clips began to loosen and wobble, and eventually I dropped the headset and the clips broke right at the bolt hole. To help with part strength, I slightly thickened the roof of the bolt hole plus added clips to provide additional strength and hold the parts together at more than one location.
I printed this in PLA with 50% Cubic infill on a Biqu B1 at 0.28mm layer height and -0.04 horizontal expansion.
They now have a more snug fit between the two halves
Category: OtherThe author marked this model as their own original creation. Imported from Thingiverse.