Anycubic Kobra Neo Extended Tray

Remixed the tray for the Kobra Neo to extend below the rollers. This allows to cover the whole open section. Notice that it is not designed for the Neo 2!

Update: The model that this was remixed from got an update for Neo2 compatible trays. See there if you have the Neo 2, for now there is no version of the extended model for the Neo 2. 

It was achieved by an additional section that goes below the level of the crossbar.  The design was done with a standing printing position in mind, but support (and eventually a raft) will be necessary. See screenshots of Cura about the preferred printing setup, I used a tree support:

Remixed the tray for the Kobra Neo to extend below the rollers.