Bass Clef Headphone Stand

Created to hold my computer headset and as a double bass player wanted something unique to me. Ends up about 20cm / 8 Inches tall and Clef is 25mm / ~1 inch wide

Prints as 2 pieces for no support printing, that can then slide together easily. Makes for easy assembly/disassembly and flat transport if required.

You could of course glue it together should you want it permanent and/or tighten the tolerances on the hole if you just want a tighter fit (I left it fairly loose so wouldn't have to re-print if it was too tight)

Remixed from Bass clef: https://www.thingiverse.com/thing:93518

and Makerbot stand: https://www.thingiverse.com/thing:2050885

Printing:

I did at 0.3 and 10% cubic as that was good enough for this piece IMHO and wanted it faster. But could do at less if you prefer a finer finish.

Print Settings

Printer:

Voxelab Aquila

Rafts:

No

Supports:

No

Resolution:

0.3

Infill:

10

Filament:

Flashforge PLA+

Black

Notes:

Each piece fits on Voxelab Aquila 220x220 bed or similar Ender 3 clone.

If you want it taller you probably can upscale still a bit more and fit.

I printed flat with no supports and .3 to save time using 3dprintSOS's Aquila profile @ 10% with cubic subdivision pattern.

Clef took ~5h Base ~3h at my settings

Category: Organization