Very helpful tool. My prints seem to be overextruding for the infill, so looks like I will have to dial down the flow setting somewhat!
Flow Calibration Matrix
This .3mf file is already set up correctly to test your printer's flow.
37
530
3
1659
updated May 31, 2023
Makes
Comments
Great to do some tests on a filament that is giving me a hard time to print like it should (at least I think it's the filament since haven't had problems before).
Would like to understand better how this .3mf works in cura, since I don't see where it changes the flow rate (on the options is always 100% but printing you can see that there are difference between them). Thanks for sharing the file. (obrigado)
Just curious, why is one box offset a bit?
@JessicaMauerhan To help you know which one is which. 60% is the one that's offset - so once peeled off of the printer you can flip it around and still know which cube represents which percentage
Just a friendy reminder :)If you use Orca slicer, it has the flow calibration build in :)
