Ultimate Speed 12V Pump - Parkside X20V Battery Adapter

Give your pump extra mobility using this conversion kit! Fits all Parkside X20V series batteries

Parts

24V to 12V 15A DC-DC Converter (74x74x32mm), do not buy over 15A as it will trigger overcurrent protection on the battery, even 15A is overkill

5.5x2.1mm 90° DC power plug

5.5x2.1mm DC power socket

6.3mm spade crimp terminals

M3x30 and M3x15 screws

M3xOD4.6xL4.5 heat insert nuts, used for attaching the battery holder onto the backplate

Installation

Print the parts, and route the +20V wire between the battery and converter under the plastic heatsink guard.

I would recommend using an M6 washer over the printed DC jack holder for extra holding strenght, check the pictures for more information.

For the battery holder you will need to hot-glue the 6.3mm spade terminals into place, you can find more information in the original thread.

Connect the output of the battery holder into the input (red and black wires) of the DC-DC converter, and connect the output (yellow-black wires) into the 90° DC power plug

Print Settings

Printer Brand: Creality

Printer: Ender 5

Rafts: No

Supports: Yes

Resolution: 0.12

Infill: 100%

Filament: PM Filament PLA+ Black

Wall Count: 3+