PG7 / CNLINKO LP-12 mount for SB2209 / SB2240

Version 2
This variation includes slots for zipties. This is particularly usefull If you are also routing the extruder cables through the umbilical instead of using the driver on your SB2209/SB2240.

Replaces the Stealthburner cable anchor to screw in a PG7 strain relief, or a CNLINKO LP-12 female socket.  

The part is small enough to not interfere with the USB-C port of an SB2209 or SB2240.  

I would recommend using a CNLINKO LP-12, since it allows you to easily remove the cable for maintenance, and allows you to more easily route the cables to the SB2209/SB2240 XT30(2+2) port. If you do opt for the PG7 instead, you will want to remove the outer sheathing at the end of the cable such that you can bend it accordingly.

If you opt for the CNLINKO LP-12, the notch of the connector should point to the left such that it does not interfere with the Z chain at the back of your v2.4.

This part works great with my exhaust cover.

Shoutouts to hartk for the original design.