Ghost PaperClip

How to build 

• Open a new sketch
• Select the front plane

Constraint Box

• Sketch a construction center-point rectangle (the second option) from the origin
• Sketch the constraint box with construction lines (13 cm x 6 cm)
• Draw an 11.4 cm line
• Draw a construction line across the top and bottom of the 11.4 cm lines
• Select ‘mirror entities’
• Select the 11.4 cm line
• Click ‘mirror about’
• Select the center construction line from the constraint box
• Exit the property manager

Arcs on Top

• Select the 3-point arcs
• Make 2 side-by-side 1.5 cm semi-circles at the top of the lines
• Select ‘mirror entities’
• Select the 2 semi-circles
• Click ‘mirror about’
• Select the center construction line
• Exit the property manager

Triangles on Bottom

• Put triangles 2 cm in width on the bottom
• Make a diagonal line from the bottom left corner of the ghost 1.4 cm long
• Repeat the previous step in the opposite diagonal direction
• Repeat the second step again until you reach the center construction
• Ctrl + select all the lines created
• Go to ‘mirror entities’
• Select the ‘mirror about’ box
• Select the center construction line
• Exit the property manager 

Eyes

• Select the surface of the ghost figure
• Make one circle with a distance of 1.1 cm from the edge, 1.6 cm away from the top, and 1.15 cm in width
• Select the circle
• Select mirror entities
• Go to mirror about
• Select the construction line
• Exit property manager

Paperclip Smile

• Make a line 4.7 cm, 1.23cm away from the right line
• Make a 2.54cm line with an angle of 135
• Select the lines
• Select ‘mirror entities’
• Go to ‘mirror about’
• Select the center construction line
• Exit the property manager
• Select the lines again
• Select ‘offset entities’

• Ctrl + select the 2 lines just drawn
• Set the parameters to 0.6 cm
• Select cap ends
• Select arcs
• Exit the property manager
• Exit the sketch

Extruding

• Select boss base extrude
• Set the thickness to 0.1 cm
• Exit the property manager