Flash quick release mount

A quick-release mount for attaching flash to tripod or other items that use a Arca-Swiss type mount. Fits Canon/Nikon flash units, and should work with most flash types with the exception of some Sony/Minolta-specific units. Can be used as a basic stand on level surfaces, indents ease the use of clamp wheel, prints with minimal supports.

Must be printed hotshoe side down to the bed.

Print instructions

Category: Camera Summary

A quick-release mount for attaching flash to tripod or other items that use a Arca-Swiss type mount. Fits Canon/Nikon flash units, and should work with most flash types with the exception of some Sony/Minolta-specific units. Can be used as a basic stand on level surfaces, indents ease the use of clamp wheel, prints with minimal supports.

Must be printed hotshoe side down to the printer bed.

Print Settings

Printer: Any

Rafts: No

Supports: Yes

Resolution: 0.2mm

Infill: 20%

Notes:

Print hotshoe side down to the bed.
Supplied Gcode is for PLA, read the above if using bed clips.
Print time approx' 1 hour.