Dirt Devil Simplistick wall mount

This is an older creation of mine from a few years back. I wanted to wall mount my Dirt Devil Simplistick inside of my closet so I printed this. I've been using it for a couple of years now without issue, and I only use this vacuum to collect my hair when I shave my head so the mount has had the vacuum removed and put back on at least once a week for a couple of years now and is holding up nicely.

The top has 2 holes with some recesses for drywall screws. Since it has been a while since I printed this, I don't remember what infill settings I used but I would recommend at least 30% or higher as this has to hold the weight of the vacuum. I do remember that I printed this in Hatchbox PLA.