Bambu Lab Profile - LWPLA
3MF File to help with High Speed (150mm/s) on the Bambu Labs X1 with LW-PLA
23
344
3
2015
updated May 2, 2023
Makes
Comments
Is it for foaming or prefoamed filaments?
I loaded this profile up on my P1P, ignored the warnings about not being an X1C, imported FUS3 from Eclipson's Go Wolf and started printing with Esun ePLA-Lite in grey. Out came a beautiful part in crazy fast time. Thank you. This part came out at 14grams. The pic showing 11 grams is my previous profile which was not producing functional parts. I think you just saved me hours of tuning time and days of printing time. Thanks again. (edited)
View 3 more comments
@StuGre_263890 i've read that i should print with normal pla settings but its not Perfect. Thanks for the reply
@Bunk I have used foaming filaments only ( exclusively Esun EPLA-Lite ).
I've printed several LW-PLA models with my Ender 5 pro and I'm just starting a Planeprint WANNA PLAY II with my new-ish Bambu Lab X1 Carbon. I was struggling a bit and your profile has saved me a lot of tweaking thank you :) The surface of the parts is near perfect with just a bit of inside stringing that is expected and easy to clean up. The parts were very slightly over the recommended weight so I've tweaked it a bit. They are still very light, super strong and rigid. It's going to make a very fine model indeed. I'll post a photo when it's done and dusted :) So thanks again. David
@carswithplugs_270141 have u used foaming or prefoamed filaments?
@carswithplugs_270141 Hello, the settings are really almost perfect. What did tou tweak about it ? See my picture of the Model 1 / Fuse01
Could you share some details of what you have actually done here? Is it calibrated settings for an LW PLA?
View 2 more comments
@MagicHappenZ_533608 I would imagine eSun foaming ePLA-LW.
@MagicHappenZ_533608 works fine with Colorfabb and eSUN foaming LWPLA, there is little between the two brands
Please feel free to give feedback and your tweaks to this project.