Parametric Bottle Holders - IKEA SKADIS - TOP version

A remix of my SKADIS bottle holder so it can hold the bottle on the TOP of the board, saving some precious space !!!!
76
233
6
1489
updated April 26, 2023

Description

PDF

I remixed my previous IKEA SKADIS bottle holder to make it so it can hold the bottle on the side. This way the bottle is not taking to much precious board space !

Here are the variations I have created so far:

Bottle Diameter (BD)70% of BD75% of BD80% of BD85% of BDExample
34mm  H15mmH15mm 
35mm  H20mm  
40mmH20mm H20mm Clipper Lighter gas
45.2mmH20mm H20mm OIL 100ml
46.5mm  H25mm  
49mmH20mm H20mm silicone/glue cartridge…
52.5mm H20mm   
53mmH20mm H20mm WD40, Grease spray 200ml/250ml 
57.75mmH20mm H20mm  
66mm H20mm  Standard BEER/SODA CAN 330ml (tight)
Standard Spray Paint (no lip) (tight)
66.2mmH15mmH15mm  Standard BEER/SODA CAN 330ml
Standard Spray Paint (no lip)
71.7mmH15mmH15mm  Standard Spray Paint (with lip)
80mmH15mmH15mmH30mm Isopropanol 1000 ml

where:

  • D is the bottle diametre, model will be 0.5mm more for better fit.
  • H is the Wall height
  • % is the overlap percentage

To print:

  • No support needed ! see picture.
    • Add brim
    • 0.2mm layer preferable, it also work @0.3 but overhang might no print as well

On the design:

  • 45° to 50° overhang max depending on parameters → no support = low waste
  • Holder diameter is 0.5mm higher than bottle diameter for perfect/easy fit.
  • Slide on the top of the SKADIS board, does not cover the holes of the board

On the Freecad file:

  • Display Spreadsheet
  • Modify cell highlighted in the screenshot

If you can't work on the Freecad file, I'll be happy to add a variations to that list.

Hope it helps !

 

Other related model:

Tags



Model origin

The author remixed this model.

License