Minicaster humbucker/Double Coil neck

I remixed the neck piece and pickguard to fit a humbucker inside.

The humbucker i used is a Guitar Tech branded one which came with an encore les paul so yours might not fit.

As long as yours is 70mm x 30mm it should fit. 

The pickguard is a little thin in one place and did snap when i was making holes for the humbucker but as a retention screw is in that corner it works perfectly fine and holds the pickup without it shifting

I didn't add holes for mounting the pickup into the pickguard just incase the spacing is different.

I used 25% infill with 7 parameters as this is what I used for the original neck piece and it worked just fine

I am including my f3d file incase you want to adjust it to fit your humbucker.