Drone holder for Ikea Skadis

As this is one of my first quads I just can't have this one laying in the corner. I used this holder before with command tape, but it fell off the wall (hence the broken prop). So I thought why not remix it a bit and use the t-nuts system again.

Made it a bit thicker so the hardware I have fits. Cleaned the model up after importing and rounded the corners a bit to make it easier to stick on the build plate.

Hardware needed:

• 2x DIN 7985 TX (M2.5 x 12)
• 2x M2.5 nut (found here)

Print settings:

I used the default PrusaSlicer settings: 0.20mm 100mms linear advance. Printed with Prusament PLA in the color Galaxy black.

Print details:

Model size: 124.77mm × 121.88mm × 25.00mm
Filament: 6.13m / 14.74cm³
Estimated print time: 01:12:24
Last print time: 01:12:17