For Dell Rugged Extreme 7202/7212/7220 Tablet Handle V2

Two angled parts for the Rugged Extreme Tablet to create a handle. 

You need a few extra Materials for this. 

Firstly, a rectangular tube with 15x15mm and a wall thickness of 1mm. Cost: ~5€ for 1000mm

My  tube needed to be cut to a length of ~194mm.  

Mount the angles and check your length. (For 7212)

Additionally, you will need two standard metric M3x16mm screws. ~ less than 1€

Total material cost less than 10€ or $. Significantly cheaper than the standard handle. 

Printing

The drop resistance depends on the % of infill used and your print quality. 

Print without supports, they are integrated in the design already. 

I recommend a brim, the outer edges may warp during printing. 

Use Ironing and a smooth flat bed for maximum surface quality. 

Cheers!