Pipe Flanges (0.5" Copper Supply & 1.5" ABS Drain) and Brackets

Pipe Flanges (0.5" Copper Supply & 1.5" ABS Drain) and Brackets

Snap Fit Pipe Flange that can be installed later and not during plumbing #3dprinting #flange #diy

Printed with 0.8mm nozzle and PLA.

Yes, if the hot water pipe gets too hot, it might warp the PLA flange - but so far I haven't had any issues.

If this designs helps you in any way, do you mind leaving me a quick tip via paypal?
http://paypal.me/avicode

Thanks!

YouTube Short Link:

https://youtube.com/shorts/Kn-OG-ss8F0