Revo Nozzle Holder 3-10 (for Prusa MK3S) - parametric

MODEL DETAILS

A clip-on nozzle holder compatible with the MK3 range of printers. Designed for RapidChange Revo Nozzles.

MAIN CHANGES

Has been parametrically redisigned in Fusion360 to allow to store from 3 to, well, I guess up to 15 nozzles. (didn't test how many would fit on the MK3S)

The E3D Logo is a bit less recessed, allowing for 2 full walls all around the front part and less overhanging perimeters in the logo.

The hole distance has been decreased by roughly 2mm to 18mm.

in the uploads section you'll find versions for 3 to 10 (who has so many??) nozzles plus the F3D file in case you want something different - just change the number of nozzles and the model will adapt itself.

(Somehow F3D acts crazy generating the 3 nozzle version, so I cheated a little to get the logo shown properly and uploaded it separately)

RECOMMENDED PRINT SETTINGS

0.4mm nozzle, 0.2mm layer height. No support material should be needed.
I'd recommend to set the perimeter width to 0.6mm - this will give you a 100% infill front part. Regular infill can be reduced to 10% or even less.

A big THANK YOU to E3D for the Revo system (and finally releasing the Obxidian) and to the original designer Will Hardy.

Well - I guess you should also
Check out E3D!