Transforming TieKnot

Here is the Transforming TieKnot.
I hope it will help alot of you out there.
You can create more badges yourself, there is a drawing shown of the empty badge, on one of
the pictures, that shows the Dimensions, a sketch.
Or you can cut the badges out of cardboard or some thick paper.

Printing:

The Transforming TieKnot Part:

0.15 mm Layer Height.
Use a brim.

The Badges:

0.2 mm Layer Height.
That is a little important, because they have to slide in a 1 mm gab.
They are 0.8 mm thick. Depends on your printer tolerances.
If you make a colorchange. Print the badges upside down, so the small dot is farthest away from were the printer starts printing.
So the nozzle is primed, else it might miss it.

Happy Printing.

Print instructions

Printing:

The Transforming TieKnot Part:

0.15 mm Layer Height.
Use a brim.

The Badges:

0.2 mm Layer Height.
That is a little important, because they have to slide in a 1 mm gab.
They are 0.8 mm thick. Depends on your printer tolerances.
If you make a colorchange. Print the badges upside down, so the small dot is farthest away from were the printer starts printing.
So the nozzle is primed, else it might miss it.