Gas Can (Midwest) Nozzle / Spout with Breathing Tube

Gas Can (Midwest) Nozzle / Spout with Breathing Tube

This is my second Gas Can Spout design.

The old design was straight with no breathing hole.

This one pours way more easily + faster + smoother.

That tube at the back is just a tube I got from a discarded soap dispenser.

Printed with 0.8mm nozzle.

CAP:

I designed a flat piece that goes in instead of the spout, when the can is used for storage.

That can be found in this old design:
https://www.thingiverse.com/thing:4928011

I kept the old cap, and just redesigned the spout part, because the old spout was not as good.

The simple cap is easy to print, and if you print on glass, it is also creates a very tight seal (air tight).

If you use PLA / PETG - please know that it will eventually get brittle.

It took about 2 years in my usage experience.

If this designs helps you in any way, do you mind leaving me a quick tip via paypal?
http://paypal.me/avicode

IMPORTANT NOTE: Please be very careful when modifying Gas Cans. Please ensure that they are air tight. You might need to make some adjustments to make the cap air tight for your own can, and that is why f3d is attached. I can't be liable for any damages.

Thanks!