Tarmo4 LED Headlights Shock Mounts

Using the components linked below I've added front and rear LED lights to the Tarmo4. This kit allows for easy, solder-less, LEDs to be added with the ability to map to a channel on your receiver for convenient on/off switching. To accommodate their mounting I've created a modified front and rear shock mount each with their own Tarmo logo on them. I've also included each version without the logo as well. Dependent on orientation the rear mount logo may need to be supported, just be careful when removing to keep intact.

LED Kit (provides front and rear lights, two on either side in one rewired harness with mounting hardware):
https://www.amazon.com/gp/product/B013SSO70Y/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

LED On/Off (allows LED kit to be directly plugged into an unused receiver channel for on/off functionality):
https://www.amazon.com/gp/product/B07BKSGW3D/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

My other Tarmo Mod - DJI FPV Mod:

https://www.printables.com/model/460286-tarmo4-dji-fpv-mod-v2 

Major props to Kris who designed the Tarmo check out the Tarmo4 here:

Tarmo4 Body - https://www.thingiverse.com/thing:4178426
Tarmo4 Suspension - https://www.thingiverse.com/thing:4178427
Tarmo4 Drivetrain - https://www.thingiverse.com/thing:4178625
 

https://www.reddit.com/r/EngineeringNS/

Print Settings

Supports:

Yes (on rear mount)

Resolution:

.20

Infill:

10%

Filament material:

PLA

Notes:

Use recommended settings and orientation from the Tarmo4 general instructions. I found it easier to print with supports on buildplate for the front shock mount, rear should not need it.