Han Solo Squirt Gun Holder

I made this model to support a Han Solo Squirt Gun (water gun); keeps it handy to squirt my cat getting into trouble.
7h 8m
1× print file
0.15 mm
0.40 mm
73.00 g
2
7
0
529
updated April 22, 2023

Description

PDF

This model is designed to support the Han Solo Squirt gun from Hasbro. It's a nice little squirt gun that outputs a minimal amount of water and shoots pretty straight compared to other squirt guns. For these two reasons it makes an ideal cat training device, you are sure to get your little fury beast getting into trouble and not have much over-spray to clean up. 

We have two of these squirt guns around the house, and to make them easy to grab, and not laying on their side to leak out water, I made a little support prop.

I printed in two colors because I had run out of filament, and left the base rather thick so that it stays stable on a table. However a 15% infill works fine and keeps the weight balanced to support and not spend too much filament. 

Model origin

The author marked this model as their own original creation.

License