Eltra Kickstand extension tab (10.9mm)

UPDATE 1: 2 separate models, one to use with M3 threaded insert and the other one is just M3 threaded. I beefed up the sides to avoid layer separation when screwing in the screws and to make it stronger. 

Extension for the kickstand, fits Eltra Escooter and a lot of other brands. If you are tired of having to bend down to lower the stand, print this so that you can use your feet to lower the kickstand.

It fits kickstands that have OD of ~10.9mm.

To attach it, use 2 M3 x 20 screws and or glue. In my case, i had to glue it on to really stay in place.

You can print it in any filament but i would recommend PETG or ASA.

Printing guidelines :

4 walls

10-15% triangle infill 

5 bottom/top layers

0.2 - 0,24 layer height.

Takes 90min to print.