This is an outdoor wall mount I made for a couple of Ubiquiti NanoStation AC PtP/PtMP bridges so I could angle them up/down and side/side. The mount it comes with is a flat wall mount.
PLA
I printed the posts on both mounts at 100% infill and the remainder at 30% infill, but all could be printed at 20%-30% infill. They're plenty strong at 2-%-30% infill because the NanoStation AC is extremely lightweight.
Addl parts: ¼" x 2" bolt, ¼" knob, ¼" washer
The NanoStation mount is in 2 colors in the picture because I ran out of black filament during the print.
The author marked this model as their own original creation.