Print in Place Bow Tie

This bow tie is all laid out in a single print, it has two articulating pieces to make a fun moveable bow just like a real bow tie. This articulation is accomplished with two print in place 180 degree hinges. The clip prints separate and easily goes on and off the tie from the center.

Print instructions

I have attached a 3MF file with all my settings built in, you can print it in PLA and it will work just fine, but if you push the bow pieces together too hard a small crack may form on the hinge. This does not fully break and the bow tie will still be fully functional, but I haven't had this problem with PETG so I recommend using it instead.