Voron Bed Mount Guide and Holder

A little tool that allows you to lock in exactly where your knurled nuts for your bed should be on your printer.
19
55
1
765
updated April 20, 2023

Description

PDF

A little tool that allows you to lock in exactly where your knurled nuts for your bed should be on your printer. I made this because putting the bed on initially was a pain in the butt and I was dreading taking it off for maintenance. I designed these to allow me to lock in exactly where the knurled nuts on my Voron 2.4 LDO version before taking off my bed. It also made installation of the bed later a breeze.

These are designed for the LDO kits and may work on other printers. It fits a 16mm knurled nut. Contact me if you need a different size. 

BOM:

  • 4 x m3 hammerhead t-nuts
  • 4 x m3x8 bolts

Directions:

  1. Print 4 holders in ABS or ASA or other heat resistant material as these will be under the heated bed.
  2. Put a m3x8 bolt through the top and hammerhead t-nut on the bolt.
  3. PRIOR to removing your bed, slip these into the extrusion near the knurled nuts for the bed.
  4. Slide it up against the knurled nut so it is snug and tighten the holder down. Repeat for all 4 corners.

 

Tags



Model origin

The author marked this model as their own original creation.

License