Pegboard Hook to Hold Gridfinity Bins without a Base

I remixed the hooks created by timbarnes (noted in the remix location) and not so much a remix of the bins themselves. The model is so specific to this bin model, I felt it was appropriate to post it here.

The hooks will hold these vase mode bins vertically in pegboard. Specifically the bins without the base. By base, I mean the piece that is glued to this model. If you are mounting them vertically, what is the point of having that base!

This remix also tightly fits ¼ inch pegboard vs the much smaller original. I print these with:

• PETG
• .4 nozzle
• .2 layer height
• 3 walls
• %10 infill
• 60mms speed
• 12 minutes (if doing one at a time)
• 2g filament