Hinged handles designed for the Voron V0
26
109
1
579
updated April 19, 2023

Description

PDF

I was looking for a good set of handles to add to my Voron V0.2 and didn't find any that I liked. Specifically, due to the new tophat design of V0.2, most options didn't allow for enough room to get my fingers around the handles.

These handles are on a hinge allowing them to lay flat when not needed but can easily be used to carry the printer.

 

Note: The hinge is designed to print in a vertical orientation to alleviate the need for supports and to maximize strength of the joint.

 

BOM

4 x M3x12

4 x M3x35 (any sufficiently long length should work)

Tags



Model origin

The author marked this model as their own original creation.

License