Quick and Easy Wall Mountable Hooks

Print Parameters

• 50%+ Favorite Infill (no lightning infill)
• 5 walls
• 0.28mm layer height

Material Use and Print Time

• 32g PLA+ filament used
• 2h 25m print time (5 walls, 50% cubic subdivision on Ender 3 Pro at 50mm/s)
• I printed in Inland PLA+ and had good strength but PETG would probably be the best material for this. 

Wall Mounting

• Hole is 6mm in diameter
• Base in 5mm in thickness so account for that in screw selection

Use Cases

• Small hooks should be plenty strong for even the biggest wad of keys
• Big hooks should be fine for a small bag or purses (especially in PLA+ or PETG)