EBB36 Mount for Creality Sprite / Ender 5 S1

BigTreeTech (BTT) EBB36 CAN Bus Mount

Suitable for the Creality Sprite as is found on the Ender 5 S1, but probably works with some other models - if not - the step is included to adjust the mountings as you wish.

---

Accompanying Ender 5 S1 rigidity bracket

I've also included a bracket to improve the rigidity of the extruder setup for folks with the Ender 5 S1, the dimensions aren't perfect - I whipped this up in a hurry but it does work.

Its mounts it to the place where the stock CR-Touch was located before doing a zero Y offset relocation.

---

New: Beta version with enclosure / lid, Rigidity mount and MP1584 buck convertor support.

See v114 files.

Note: untested!