KP3S Shorter Part cooler (27mm) for V6 nozzles

This was modified from the official model that comes on the SD card of the v2 KP3s

I bought the Kingroon official titanium and stainless steel heat breaks.  Both had a shorter heat block connector thread.  I use this with a V6 Nozzle instead and it'll fit. Unfortunately the original part cooler is now too long.

I made this version just 27mm tall. 

Note: I printed the model on its back (nozzle pointing up) and without a part cooler (as it didn't fit) that waft of the fan was enough!