I also do a lot of filament changes on my sv06 and plus so stumbling across these seems like a no brainer for me. Printed up 2 sets really quickly in PETG and slapped them on, initial impressions are good, I left a the knobs a bit loose so I can freewheel them like a machine handle and so far it’s awesome. Thank you for sharing this.
Anyone know if this would also fit the SV07 plus?
I needed a longer M3 screw, like M3x12.
Don't know if I did something wrong, but M3x6 was way too short.
@Johan501 you're right, my mistake. It's M3x10~12mm. Thanks for your reminder.
@GumoDesign you're welcome! :)
How to connect knob to wheel ?
@JeroenWagemak_781819 It would be the best if you have a M3x10mm screw. (edited)
