Corne low-profile case

This is a flat case designed for the Corne (crkbd) keyboard by foostan. More specifically, it fits variants which connect between halves using a TRRS cable, and it is designed to replace the bottom plate in a three-pcb stacked build. If you have a corne that is currently built this way, you won't need any extra hardware (if not, you need 10 m2x7.5+mm standoffs and 10 m2x4mm screws).

There are two variants of this case: one with a cutout for a right-angle TRRS cable as shown in the photo, and one with a 7.5mm diameter circular cutout. This is the right-angle cable I use.

There is ONLY ONE SIDE for this model! Duplicate and mirror the model across the X axis in your slicer to print the right half.

I printed mine with 100% infill (for weight) at 0.16mm layer height. Enable supports on the build plate only  - this will help with clean screw holes on the bottom of the case, which you can then pop out later with a screwdriver or allen key. If you print the version with right angle cutouts, depending on your printer you may need supports.