Drybox Tray

Simple tray to sit the Drybox in on top of your Lack Enclosure or whatever.

Saves screwing the drybox down to stop it being dragged around. Stick these down with double side tape, sit the box in the tray, job done. Simple.

Updated the tray as it was to shallow to hold the boxes properly on the lid when it was lifted. Utilising a clamp design over the dry boxes and these deeper trays you can lift the lid to service the MMU without unloading everything

Print instructions

Print with whatever settings you choose for the material being used. I ended up using a 0.6mm nozzle as i installed it to print the Dryboxes (cut print time in half!)