Stroller Klips

This is a pivoting system for attaching various items to a stroller frame built with 16mm tubing or larger.  The ToolMount bolt can be secured tightly so that no pivoting occurs if desired.  This was originally created several years ago by me to attach various items to my  walking cane but was easily adapted for use with a baby stroller.

The ClipMountInner and ClipMountOuter attach to the stroller frame using ½ inch long 6-32 screws and secured with lock nuts.

The ToolMount attaches to the ClipMountInner by either 3d printing the provided ToolMountBolt and ToolMountRetentionNut or by using a 10-24 hex drive screw ¾ inches long with a matching nut. 

The McMaster Carr part numbers:

• Two ½ inch long 6-32 screws part# 91249A148
• Two 6-32 lock nuts part# 90631A007
• One ¾ inch long 10-24 hex drive screw part #92949a245
• One 10-24 nut part #91581A335

After the ToolMount is attached to the stroller, accessories may be easily changed by sliding them onto the ToolMount.  The following accessories are provided:

• soda can holder/coffee holder
• cellphone holder
• flashlight holder
• fabric pouch holder

The bolts and nuts, if you choose to print them, should be printed at 0.2mm layer height.  

The ToolMount and related items should be printed at 0.2mm layer height. 

The cup holder and phone holder accessories may be printed at 0.28mm layer height if desired.  Supports will be needed.

The pouch holder clip and flashlight holder clip need to be printed at 0.2mm or the screw threads will be too tight for the wingnut to insert.

A StrollerClips STEP file is provided containing the full assembly with all accessories so that you can modify the accessories to your needs or create more accessories.